MQL Machining – Oil on Water Droplet System

MQL Machining – Oil on Water Droplet System

EKINOVIC, Sabahudin
BEGOVIC, Edin
LUSIJA, Aldin

Flood and through-tool delivering of cutting fluids have been widely used for the machining operations. The use of a large amount of cutting fluid can impact the environment and increase manufacturing costs, and possibly lead to ground contamination, excess energy consumption, the need for wet chip disposal and potential health and safety issues. Minimum Quantity Lubrication (MQL) machining involves the application of a minute amount of oil-based lubricant to the machining process in an attempt to replace the conventional flood coolant system. This paper presents a classification of MQL methods, discussing their advantages and drawback. Also, the results of measurements of cutting forces and surface roughness when machining one type of aluminum bronze using MQL, are presented. As a medium for cooling and lubricating a system of oil-on-water was used. The results show that the cutting force of less than 16%, and also parameters of surface roughness, compared to machining without the use of coolant and lubricants. Keywords: mql machining, oil-on-water droplet, aluminium bronze, cutting forces, surface roughness.

Article
PeerReviewed

ISSN 2233 - 0054

International Burch University

2014-06

2747